ESP32 S3 AI Explorer Camera Board with 1.8 inc TFT Display
The OceanLabz ESP32-S3 AI Explorer Development Board is a powerful AI and IoT platform featuring ESP32-S3, 16MB Flash, 8MB PSRAM, Wi-Fi, Bluetooth, OV3660 camera support, INMP441 m...
Flash Firmware Directly from Browser
Connect your ESP32 S3 AI Explorer Camera Board with 1.8 inc TFT Display board to your computer using a USB data cable. Click the button below to pair with your serial port and flash the official AI Xiaozhi firmware in seconds.
Hardware Checklist
- βMicrocontroller: ESP32-S3 Development Board
- βDisplay: TFT 1.8" Module (I2C / SPI)
- βMicrophone: INMP441 Omnidirectional I2S Mic
- βAudio Output: MAX98357A I2S DAC Amplifier + Speaker
- βCamera Module: OV2640 Sensor
- βConnection: USB Type-C Data Cable (for power & flashing)
Video Walkthrough
YouTubeWatch step-by-step assembly, pairing with the Xiaozhi platform, and live voice interactions.
Step-by-Step Hardware & Setup Guide
Follow the wiring connections, component details, Wi-Fi pairing instructions, and voice commands below.
Introduction
The OceanLabz ESP32-S3 AI Explorer Development Board is a powerful AI and IoT platform featuring ESP32-S3, 16MB Flash, 8MB PSRAM, Wi-Fi, Bluetooth, OV3660 camera support, INMP441 microphone, MAX98357A audio, Micro SD, and USB Type-C. Ideal for Edge AI, voice assistants, computer vision, robotics, and IoT projects with support for Arduino IDE and ESP-IDF.
In this tutorial, we will set up XiaoZhi AI on the OceanLabz ESP32-S3 AI Explorer Development Board. By the end of this guide, your board will be fully configured and ready to use as an AI voice assistant.
Required Components
| Component | Description | Qty |
|---|---|---|
| ESP32-S3 AI Explorer Board | Board | 1 |
| 2W 4Ξ© Speaker | 2W 4Ξ© Speaker or any available speaker up to 16Ξ©. | 1 |
| 1.8 inc TFT Display (SPI) 128x160 | Shows pairing code, Animations and more! | 1 |
Front Side
Back Side
Circuit Diagram
Flash Firmware (Browser-Based)
No Arduino IDE required β flash directly from your browser using Web Serial.
- Click "CONNECT" below
- Hold BOOT button on ESP32 and connect USB
- Select the ESP32 port and click Connect
- Choose "Install OceanLabz ESP32" and click Install
- Wait 2 minutes for completion

Wi-Fi Configuration
After flashing, the ESP32 creates a hotspot named Xiaozhi-XXXX.
- Connect to this Wi-Fi (no password)
- Open
192.168.4.1in browser - Select your home 2.4GHz Wi-Fi and enter password
- Device will restart and connect to your network

Create Account & Pair

Pair Your ESP32
